Kyosho Inferno MP9e Evo V2: 1/8 Brushless Buggy Specs and Setup
The Kyosho Inferno MP9e Evo V2 is a 1/8 scale four-wheel-drive electric buggy based on Kyosho’s racing MP9 platform and sold ready to run as a “Readyset”. It uses a Kyosho Speed House TORX 8+ 2300 kV brushless motor with a 4S-ready ESC, a waterproof high-torque steering servo, three sealed oil-filled differentials, and has a 325 mm wheelbase, 254 mm track and about 3.37 kg weight. It brings race-car handling to bashers and club racers without building a kit.

Specifications
| Item | Value |
|---|---|
| Scale / drive | 1/8, shaft-driven 4WD |
| Length / width / height | 490 / 307 / 180 mm |
| Wheelbase | 325 mm (adjustable) |
| Track (F/R) | 254 mm |
| Weight | About 3,370 g |
| Motor | TORX 8+ 2300 kV brushless |
| Battery | 4S LiPo (or 2× 2S) |
| Diffs | Front, centre and rear sealed oil diffs |
From Kyosho and dealer listings, checked October 2026.
Top speed
Kyosho doesn’t headline a top speed. Like other 4S 1/8 buggies, it’s built for acceleration and handling on tracks and dirt rather than straight-line speed runs. Gearing and battery voltage determine top speed; taller gearing adds speed but increases motor heat. Check motor temperature after short runs when changing gearing. Motor basics are in how to choose a brushless motor.
Handling
The MP9 platform comes from racing, so the Evo V2 has a low centre of gravity, long-travel oil shocks and race-type geometry, including front hubs with generous caster. It corners hard and jumps well. Three oil diffs let you tune how power is split, which is the main tuning tool on 1/8 buggies.
Setup basics
- Check ride height and droop before driving.
- Thicker centre diff oil gives more forward drive; thinner gives smoother power on low grip.
- Adjust front diff oil for steering on and off power.
- Change shock oil and springs for track bumps.
- Choose tyres for your surface; they matter most.
Maintenance
- Clean after dusty runs and check bearings.
- Check diff oil and seals periodically.
- Inspect drive shafts and pins for wear.
- Check motor and pinion screws.
- Refill shocks and check for leaks.
Electric vs nitro MP9
The nitro MP9 TKI4 is the racing platform; the MP9e brings electric convenience: no fuel, quieter running, instant starts and easier maintenance. Parts overlap between versions for many suspension components, which helps with spares. Nitro cars in general are covered in radio control nitro cars.
Who it suits
It suits drivers who want a quality 1/8 buggy ready to run, for club racing or serious bashing, and who’ll maintain it. Beginners can use it with lower-power settings and practice, though a rugged 1/10 might be easier to start. Battery charging and care are in how long to charge an RC car battery.
Batteries
Use a 4S LiPo with a hard case and the connector the ESC uses, or two 2S packs in series if the car is set up for them. Check pack size fits the tray, set the ESC’s low-voltage cut-off, and never run the battery below its safe limit. A good balance charger is essential.
What’s in the box
The Readyset comes with the chassis built, the motor, ESC and steering servo fitted, a painted body, mounted tyres and a 2.4 GHz radio. You need to add a 4S LiPo battery (or two 2S packs) and a suitable charger, plus batteries for the transmitter. Before the first run, check that all wheel nuts and motor screws are tight, set the transmitter trims, and calibrate the ESC to the radio as the manual describes.
FAQ
What battery does the MP9e Evo V2 use?
4S LiPo.
How heavy is it?
About 3.37 kg.
Is it ready to run?
Yes, as a Readyset; you add battery and charger.
Can I race it?
Yes; it’s based on a race platform.
More on this topic: the complete RC Cars guide covers the basics behind this article.




