Illustration: Hanging RC planes – SwellRC RC Airplanes guide

How to Hang RC Planes From the Ceiling or Wall (Garage Ideas)

RC Airplanes

The safest way to hang an RC plane is from ceiling hooks screwed into a joist (not just drywall), with two or three lines attached at strong points such as the wing tube, the landing gear or straps around the fuselage at the balance point. Use braided fishing line or thin steel wire with crimps for light foam planes, cord or chain for heavier ones. Wall racks and pegboard save ceiling space and keep planes ready to fly. Here’s how to do each.

Updated: October 20264 min read

Illustration: RC planes hanging from a garage ceiling – SwellRC RC Airplanes guide

Which hanging method is best?

Method Holds Best for Notes
Ceiling hooks + fishing line (two or three points) Small and medium foam planes Display, park flyers Use 20–50 lb braided line; looks invisible
Ceiling hooks + steel wire or cord Heavier balsa planes Sport and scale models Crimp or tie securely; check yearly
Pulley hoist (rope or bike-lift style) Large planes Garages with high ceilings Lowers the plane without a ladder
Wall rack with padded arms Wings and fuselages Planes you fly often Saves space, easy access
Pegboard hooks Small foamies, wings Workshops Pad the hooks with foam tube
Nose-up wall mount (prop shaft or spinner) Light 3D foamies Profile planes Only for very light planes

How to hang a plane from the ceiling

  1. Find a joist with a stud finder. Screw hooks into wood, not drywall alone. For plasterboard between joists, use toggle anchors rated well above the plane’s weight.
  2. Choose lifting points: for planes with a wing tube, loop the line around the wing root on both sides; otherwise use soft straps around the fuselage just in front of and behind the wing, or around the landing gear legs.
  3. Find the balance point (the CG marked on the plans) so the plane hangs level. Two lines on either side of the CG, or three for a stable “flying” pose.
  4. Adjust angles with line length to make it look like it’s in a turn or climb.
  5. Secure everything: remove batteries, tape or remove props if people walk underneath, and check knots after a few days.

Protect the plane while it hangs

  • Don’t hang foam planes by thin line directly on soft edges; it cuts in. Use wide straps or pads.
  • Keep planes out of direct sunlight and away from heaters; heat sags covering and warps foam.
  • Garages get hot in summer: covering wrinkles; re-shrink it before flying (covering guide).
  • Never store LiPo batteries inside hanging planes.
  • Dust collects on top surfaces; a light sheet or periodic dusting helps.

Wall racks and DIY ideas

  • Wing racks: pairs of wooden arms padded with pipe insulation; store wings vertically, leading edge down.
  • Fuselage cradles: foam-lined U-shapes screwed to the wall.
  • Ladder racks: a ladder mounted horizontally under the ceiling holds several planes on padded rungs.
  • Bike hooks with foam sleeves hold small planes by the landing gear.
  • Shelves with a lip work for small foamies and helicopters.

Hanging a toy plane in a child’s room

Use a single ceiling hook in a joist, clear fishing line tied around the fuselage at the balance point, and hang it out of reach and away from the bed. Remove batteries and secure loose parts that could fall.

FAQ

What is the best way to hang RC planes in a garage?

Ceiling hooks in joists with two or three lines at strong points, or a pulley hoist for large planes. Keep them away from the garage door’s path.

How do I make a hanging plane look like it’s flying?

Use three lines of different lengths to tilt it into a bank or climb, and hang it where you see it from the side.

Can hanging damage an RC plane?

Only if lines cut into foam, it hangs in heat, or the mount fails. Use padding and joist-mounted hooks.

How heavy a plane can I hang from drywall?

Avoid drywall-only mounts for anything but tiny foamies. Use joists or rated toggle anchors.

More on this topic: the complete RC Airplanes guide covers the basics behind this article.

Kyle Hilson, author of SwellRC

About the author: Kyle Hilson

About 20 years in RC. Mostly boats in the NAVIGA Mini Eco Expert class, with many self-made parts; also a King Motor Baja 5B, a home-built electric plane, home-built nitro planes he has flown, and an RC helicopter. More about SwellRC